Cleaning the Note Acceptor

The acceptor head sensors and note path area needs to be cleaned every two years or as needed.

Use soft, lint free cloth to wipe and clean the area. For stubborn dirt, a small amount of mild, non-abrasive soap maybe applied to a damp cloth.

Caution:  Never use a petroleum-based product to clean this device. Petroleum based products damage the note path. Mild, non-abrasive soap is preferred over alcohol.

1.Remove the Acceptor Module from the Chassis.

2.Open the Acceptor Module by pulling forward and up on the yellow cap.

3.Clear the note path of any foreign objects.

4.Wipe the note path and sensor area with a soft, lint free cloth.

5.Make sure no streaks or residue from the cleaning product remains on the note path.

6.Close the Acceptor Module and slide it back into the Chassis so that the release lever locks in place.